Get In, Shut Up, Hold On - new mantra... ;-)
I like the cubby without the cup holder attachment, for sunglasses and other accouterments, but it is quite ugly just open.
Solution: I cut a piece of aluminum to the size and shape of the cubby, and wrapped it in leather. I will attach 1/4/x1/16 inch neodymium magnets into indented holes in the corners of the cubby, and steel washers (zinc coated) to the aluminum cover for a "snap-in" connection. I had the magnets and the leather was leftover from the seat upholstery; the aluminum was leftover from the cold-air box and shroud. So, it was essentially a free mod.
I used larger magnets like the one below to hold the coil covers down at the fuel rail - after cutting out the tops, the clips on the underside were no longer functional. Red circles are the nuts from the #8 stainless screw holding the magnet. These have like 23 pounds of pull - very strong for only being 3/4x1/8 inches.
